Source

Access model & connectivity — found from sitemap — ZeroTier

Checked for ZeroTier on 5 Nov 2026

Technical details

type: page
http status: 200
content hash: sha256:b6032c9ae424e2d1e14f95dfccfdfc93db6713774176053744b6349636b0ba9b
permission: robots_ok
screenshot: Screenshot on file (internal exhibit, not published)

Cited by

Aws vpc gateway guide Report an error

“This guide assumes that you've already created an Amazon VPC and you want to make it accessible from a ZeroTier virtual network and vice-versa.”
Udp port 9993 Report an error

“it should have a security group that allows bidirectional UDP traffic on port 9993 at a minimum. We recommend allowing all UDP traffic since ZeroTier can bind to other ports as well.”
T2 nano sufficient Report an error

“ZeroTier doesn't require much CPU or memory. Unless you're planning on pumping a lot of data a t2.nano instance is typically sufficient.”
Controller API Report an error

“go to ZeroTier Central (or your own controller's API) and authorize the gateway on your virtual network.”
Ipv4 forwarding Report an error

“Edit /etc/sysctl.conf and set net.ipv4.ip_forward to 1.”
Custom routes Report an error

“In ZeroTier Central (or via your own controller's API) add a route to your VPC's IP address range via your gateway's ZeroTier-side IP address”
Avoid ip conflict Report an error

“It also assumes that your VPC's IP address scheme does not conflict with the one you use in your ZeroTier network. If it does we recommend renumbering one or the other.”
Route propagation delay Report an error

“It may take a minute or two for this route to become available on ZeroTier nodes.”